Treatments & Procedures
No two spine conditions are exactly alike, and neither are the treatments that may be recommended for those conditions. Dr. Dixon offers a comprehensive range of surgical and non-surgical solutions, using advanced techniques and technology to minimize disruption, preserve mobility, and help patients return to the activities they love.
Minimally Invasive Spine Surgery
Motion-Preserving Spine Surgery
Advanced Spinal Fusion
Robotic-Assisted Spine Surgery
Recovery & Returning to Activity
Minimally invasive techniques use smaller incisions and specialized instruments to treat spinal conditions while limiting disruption to surrounding muscles and tissues. For eligible patients, these approaches may reduce postoperative discomfort, shorten recovery, and allow for outpatient treatment.
Endoscopic Medial Branch Transection
A minimally invasive procedure for lower back pain caused by arthritis of the lumbar facet joints. Using a small endoscope, Dr. Dixon transects the medial branch nerve responsible for transmitting pain from the affected joint, without targeting the nerves that control the legs.
Diagnostic injections are required to determine whether this procedure is appropriate. It is performed on an outpatient basis, with many patients returning to activities within approximately two weeks.
Endoscopic Discectomy & Decompression
Used to treat lumbar disc herniations and spinal stenosis that compress spinal nerves. A small endoscope allows Dr. Dixon to remove herniated disc material or relieve narrowing around affected nerves with minimal tissue disruption.
This outpatient procedure may allow for rapid mobilization and, in selected patients, postoperative discomfort can be managed with medications such as acetaminophen or ibuprofen when appropriate.
Minimally Invasive TLIF (MIS TLIF)
Transforaminal Lumbar Interbody Fusion is used to treat spinal instability, stenosis, and nerve compression.
Rather than extensively dissecting the surrounding muscles, Dr. Dixon uses tubular instruments to gently separate muscle fibers, remove arthritic tissue, decompress nerves, and stabilize the spine with an interbody spacer, screws, and rods.
This muscle-sparing approach can reduce tissue disruption compared with traditional open techniques and may support a faster recovery.
Lateral Lumbar Interbody Fusion (LLIF / XLIF)
A minimally invasive approach used to treat spinal stenosis, instability, and deformities such as scoliosis or kyphosis.
Through an incision along the patient's side, Dr. Dixon places an interbody spacer to restore disc height, improve spinal alignment, and help relieve nerve compression. This technique may be combined with minimally invasive posterior screws and rods.
The lateral approach can provide substantial correction of spinal deformity while avoiding some of the tissue disruption associated with traditional posterior approaches.
Spinal fusion is sometimes necessary, but it isn't always the only option. Dr. Dixon offers motion-preserving procedures designed to relieve nerve compression and address degenerative conditions while maintaining movement at the affected spinal segment.
Cervical Disc Replacement
Used to treat cervical radiculopathy, including arm pain, numbness, or tingling caused by disc herniation or certain types of stenosis.
The damaged disc is removed through an anterior approach and replaced with an artificial mobile implant. Unlike fusion, disc replacement maintains movement at the treated level.
Research suggests that cervical disc replacement may reduce adjacent-level degeneration and the need for additional surgery in appropriately selected patients. It is often performed on an outpatient basis.
Cervical Laminoforaminotomy / Microdiscectomy
A minimally invasive, motion-preserving procedure for specific cervical disc herniations or nerve compression.
Through a small incision at the back of the neck, tubular instruments gently separate the muscles to access the affected nerve and remove the source of compression.
Because this procedure requires specific anatomy and pathology, not all patients are candidates. It is typically performed on an outpatient basis.
Cervical Laminoplasty
A motion-preserving procedure used to relieve compression of the spinal cord.
Through a posterior incision, Dr. Dixon creates a hinge on one side of the vertebral lamina and an opening on the other, expanding the spinal canal to create additional space for the spinal cord.
This approach can decompress the spinal cord while avoiding fusion and preserving cervical motion.
Lumbar Disc Replacement
Designed for select patients with debilitating lower back pain caused by degenerative disc disease that has not responded to conservative treatment. In certain cases, it may also address lumbar radiculopathy.
An access surgeon assists with an anterior approach to remove the damaged disc and replace it with an artificial mobile implant.
By maintaining movement at the treated level, lumbar disc replacement may reduce stress on adjacent spinal segments. Some eligible patients may undergo this procedure on an outpatient basis.
Lumbar Facet Replacement
An alternative to fusion for selected patients with arthritic lumbar facet joints, particularly when the intervertebral disc remains relatively healthy.
The damaged facet joints are removed and replaced with an implant designed to maintain spinal movement while addressing pain and nerve compression.
In certain cases, facet replacement may also be an option for patients with spondylolisthesis, depending on their anatomy and overall spinal condition.
Lumbar Laminoforaminotomy / Laminectomy
These decompression procedures remove bone spurs or portions of the posterior spinal structures to relieve pressure on lumbar nerves, commonly caused by degenerative arthritis and spinal stenosis.
When appropriate, Dr. Dixon favors minimally invasive laminoforaminotomy techniques that preserve midline structures and surrounding soft tissues.
By limiting disruption to the spine's supporting anatomy, these procedures may help preserve spinal biomechanics and reduce postoperative back pain. They do not typically require implants and can often be performed on an outpatient basis.
Lumbar Microdiscectomy
A minimally invasive procedure used to relieve leg pain and neurological symptoms caused by a herniated lumbar disc.
Through a small incision, often approximately 2 centimeters or less for a single level, Dr. Dixon uses tubular instruments to remove the portion of the disc compressing the affected nerve.
This motion-preserving procedure does not require implants and is typically performed on an outpatient basis.
When motion-preserving procedures cannot adequately address spinal instability, severe degeneration, deformity, or other complex conditions, fusion may be necessary.
Spinal fusion stabilizes affected vertebrae by allowing them to heal together into a single structural unit. Dr. Dixon uses fusion selectively, prioritizing motion-preserving alternatives whenever medically appropriate.
Anterior Cervical Discectomy & Fusion (ACDF)
A well-established procedure for treating cervical nerve or spinal cord compression, as well as selected trauma and infectious conditions.
Through an incision at the front of the neck, the damaged disc and compressive bone spurs are removed, followed by placement of a fusion implant.
Although highly established, fusion eliminates motion at the treated segment and may increase stress on adjacent levels over time. Dr. Dixon considers motion-preserving alternatives when appropriate.
One- and two-level ACDF procedures can often be performed on an outpatient basis.
Posterior Cervical Laminectomy & Fusion
Used to treat multilevel spinal cord compression, certain spinal deformities, or conditions requiring revision after previous anterior cervical surgery.
Through a posterior approach, portions of the bone covering the spinal cord are removed to relieve compression, and instrumentation is placed to stabilize the spine.
Anterior Lumbar Interbody Fusion (ALIF)
An approach to lumbar fusion that accesses the disc from the front of the body with the assistance of an access surgeon.
The damaged disc is removed and replaced with an interbody spacer, typically titanium and filled with bone graft, to promote fusion between adjacent vertebrae.
ALIF is commonly performed at L4-L5 and L5-S1, and occasionally L3-L4. It can restore disc height, improve lumbar lordosis, correct selected deformities, and address revision cases.
Dr. Dixon may combine ALIF with robotic-assisted instrumentation.
Lateral Lumbar Interbody Fusion (LLIF / XLIF)
This technique approaches the lumbar spine from the side, placing a bone-graft-filled spacer between vertebrae to restore disc height and promote fusion.
It is commonly used at L3-L4 and higher levels, with selected applications at L4-L5.
LLIF / XLIF can treat stenosis, instability, arthritis, spinal deformity, and certain revision cases. It may be combined with robotic-assisted posterior instrumentation and, in selected situations, performed on an outpatient basis.
Transforaminal Lumbar Interbody Fusion (TLIF)
A fusion technique used to treat spinal stenosis, nerve compression, instability, and degenerative conditions, as well as certain traumatic, infectious, or deformity-related problems.
Dr. Dixon prefers a minimally invasive tubular approach whenever possible, allowing decompression and placement of an interbody spacer, bone graft, screws, and rods while limiting muscle disruption.
Some patients may be candidates for outpatient TLIF, and robotic technology is frequently incorporated into surgical planning and instrumentation.
Posterior Lumbar Interbody Fusion (PLIF)
A posterior fusion technique typically involving placement of two interbody spacers filled with bone graft.
PLIF may be selected when more extensive decompression, correction, or stabilization is necessary, including certain deformity or instability cases.
This approach is more commonly performed through a traditional open incision and may involve an overnight hospital stay. Robotic-assisted instrumentation may also be used.
Dr. Dixon utilizes the Globus Excelsius robotic platform to support planning, navigation, and instrumentation during spinal fusion surgery.
The system allows Dr. Dixon to plan implant positioning before surgery and guide hardware placement with robotic assistance.
Integrated surgical navigation provides detailed spatial information about the patient's spine during the operation, helping verify anatomical locations and guide precise surgical execution.
When combined with minimally invasive techniques, robotic assistance supports Dr. Dixon's goal of performing complex procedures with accuracy while limiting unnecessary tissue disruption.
Dr. Dixon believes recovery begins well before surgery. Patients are actively involved in understanding their treatment options, selecting the appropriate procedure, and preparing for rehabilitation.
Whenever possible, minimally invasive, endoscopic, and motion-preserving techniques are used to support earlier mobility and recovery.
Each patient receives procedure-specific instructions, education, and a rehabilitation plan that may include formal physical therapy.
A dedicated care team helps guide patients through recovery, answer questions, and establish realistic expectations for returning to work, recreation, and everyday activities.